Learning, always learning...

Well, last night was a very mixed bag. For everything that went right, I had to learn something from something that went wrong. It started with working on a Tulipwood Classic American pen. The pen itself came out pretty well, but even though I paid particular attention to getting the wood flush with the bushings, the end result was not flush with the kit on the upper barrel. I think (I will have to confirm this later) that the bushings themselves have gotten sanded down a bit, so making the wood flush with the bushings will make it slightly below where it should be for the finished product. I have no problem getting a new set of bushings if that is the case. If that is NOT the case, I have no clue what is going on.

While putting together the CA pen, I learned how (for the first time) to use the file that I bought recently. The fit between the upper and lower barrels was very tight (and it is supposed to be fairly loose). The recommended way to handle this is to file down the inside of the upper barrel. I had never done this before, but it worked pretty well when I did it for the first time.

Then I went to work on a Tulipwood click pen. This one was one that I was trying to resurrect, as the tube had gotten stuck in the blank during the gluing process. So, I cut off the tube part that was outside the blank, and glued it into the other side. This seemed to work fine, until the part where I was assembling the pen. I made the bad decision to use the "short tube" part as the part of the upper barrel that was nearest the center. When I pressed a part of the kit into this end of the tube, the short piece of tube came unglued. So, I tried to reglue the tube into the upper barrel, and then press the pen together, and the wood split. So, 1 for 2 so far, for those counting at home.

The tiebreaker would be a cocobolo slimline pen. This pen worked fine all the way to the last part of putting the pen together. At that point (as had happened with an olivewood slimline pen a while back), the glue holding the upper tube inside the upper barrel came loose, and the tube came out. I decided to use the thin fast-acting glue to put the tube back into the barrel, and the tube got stuck halfway in. So, I have a ridiculous-looking approximation of a slimline pen.

1 for 3 on the night, and even the 1 had issues. Hopefully I will be able to come up with some quality work soon.